solder smoke absorber Email

News

solder fume extractor installation using instructions

Solder fume extractor three-stage filtration system installation, fume extraction pipe installation, fume extraction port distance adjustment, power on the use of instructions.

solder fume extractor installation instructions1. Filter installation instructions
Open the top cover of the host, from the bottom to the top of the chassis in order to correctly install the Hepa high-efficiency activated carbon integrated filter, Medium-effect filter core, Primary filter cotton, and then put the top cover on, while the downward pressure to fasten the buckle on both sides.
(Note: Before the installation of the filter cartridge, please check whether there is debris inside the host, and it is strictly prohibited to use the machine without placing the filter cartridge in the rotating state.)

2. Fume extraction pipe installation instructions
Take out the fume extraction pipe set into the flange of the top cover and rotate the tube body, align the smoking hood to the place where the solder fumes need to be inhaled, and adjust the distance of the smoking mouth according to the different occasions of use.
(Note: When adjusting the direction of the Fume extraction pipe, try to keep the pipe gently curved, otherwise it will affect the inhalation force, the Fume extraction port should be facing the working point, and the distance should be kept within 15cm as far as possible, and please do not use it in places with high air flow, so as not to reduce the suction force or disappear.)solder fume extractor installation instructions
3. Power on using instructions
Connect the power supply and test whether the power plug is stable and firm.
turn on the power switch, adjust the speed knob, so that the machine works according to the required air volume size.
(Note: Before opening the solder fume extractor, the speed switch to the OFF position, the air volume adjustment to the actual needs of the prevailing, not too large or too small, the amount of wind suction too large at the same time will increase power consumption and noise.)solder fume extractor using instructions

Prev:
Next:

Online review Message

Contact us